Page Comparison

...

Control and Test Sessions:

Control Session: Establishes the parameters for the test session, such as the IP addresses, ports, packet sizes, and the duration of the test.
Test Session: Where the actual performance measurements occur, involving the exchange of test packets between the two endpoints.

Key Metrics

Latency: The time taken for a packet to travel from the sender to the receiver and back.
Jitter: The variation in latency over a series of packets.
Packet Loss: The number of packets sent that are not received by the destination.

Vince's Confluence

https://ipinfusion.atlassian.net/wiki/spaces/CE/pages/91193347/TWAMP

Client Cnnfig

use local-loopback ( Sender ) and remote loopback ( receiver )

Code Block

title	twamp config

+
hardware-profile filter twamp-ipv4 enable

R5LAB#show running-config twamp
twamp-light control
 control-admin-state enable
twamp client
 connection R6
  server ipv4 10.10.100.6
  session R6 sender-port 2000 receiver-port 2000 sender-address ipv4 10.10.100.5 receiver-address ipv4 10.10.100.6
 exit-connection

show twamp client connection

show twamp client session

Code Block

title	show clienty

R5LAB#show twamp client connection

connection Name Server address  Server port     VRF     Status
R6            10.10.100.6           862       default       Running
R5LAB#show twamp client session

Connection name  Session name    Sender        Receiver      State
R6               R6              10.10.100.5   10.10.100.6   Session started
R5LAB#

Server Client

Code Block

title	twamp config

R6LAB#show running-config twamp
twamp-light reflector
 reflector-admin-state enable
twamp server
 server-admin-state enable

show twamp server status

show twamp server connection

show twamp server session

Code Block

title	show server

R6LAB#show twamp server status
Status                    : Enabled
Listening Port            : 862
Server VRF list           :
Number of connections     : 1
Number of sessions        : 1
Number of running sessions: 1



R6LAB#show twamp server connection
Connection ID                           Client Address   Client Port
            1                              10.10.100.5         46784



R6LAB#show twamp server session
Connection ID                            Session Id                                   Sender                                 Receiver       State
            1 0A.0A.64.06:E00FC1220EE2C98E:E976003A                              10.10.100.5                              10.10.100.6     Started
R6LAB#



R6LAB#show twamp server session 0A.0A.64.06:E00FC1220EE2C98E:E976003A
State           : Started
Connection ID   : 1
Session ID      : 0A.0A.64.06:E00FC1220EE2C98E:E976003A
Sender address  : 10.10.100.5
Sender port     : 2000
Receiver address: 10.10.100.6
Receiver port   : 2000
Receiver VRF    : default
Start time      : -
Timeout         : 0 sec

Versions Compared

Old Version 3

New Version 4

Key