Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Code Block
titleshow interface
collapsetrue
localhost#show interfaces status
Port       Name        Status       Vlan     Duplex Speed  Type            Flags
Et1                    connected    1        full   unconf EbraTestPhyPort
Et2                    connected    1        full   unconf EbraTestPhyPort
Ma1                    connected    routed   a-full a-1G   10/100/1000


localhost#show ip interface brief
Interface              IP Address         Status     Protocol         MTU
Loopback0              10.0.0.1/32        up         up             65535
Management1            10.0.2.15/24       up         up              1500



On spine01 and spine02

Code Block
titleIP and BGP configuration cmds
collapsetrue
Spine1:
-------
interface Ethernet1
   no switchport
   ip address 10.1.2.1/30
!
interface Loopback0
   ip address 10.0.0.1/32
!
ip routing
!
router bgp 65000
   router-id 10.0.0.1
   neighbor 10.1.2.2 remote-as 65000
   neighbor 10.1.2.2 maximum-routes 12000
   network 10.0.0.1/32
!


Spine2:
-------
interface Loopback0
   ip address 10.0.0.2/32

interface Ethernet1
   no switchport
   ip address 10.1.2.2/30
   
ip routing 
   
router bgp 65000
   router-id 10.0.0.2
   neighbor 10.1.2.1 remote-as 65000
   neighbor 10.1.2.1 maximum-routes 12000
   network 10.0.0.2/32

.



show ip bgp summary

show ip bgp neighbors

...

Code Block
titleshow ip route
collapsetrue

localhost#show ip route

VRF: default
Codes: C - connected, S - static, K - kernel,
       O - OSPF, IA - OSPF inter area, E1 - OSPF external type 1,
       E2 - OSPF external type 2, N1 - OSPF NSSA external type 1,
       N2 - OSPF NSSA external type2, B I - iBGP, B E - eBGP,
       R - RIP, I L1 - IS-IS level 1, I L2 - IS-IS level 2,
       O3 - OSPFv3, A B - BGP Aggregate, A O - OSPF Summary,
       NG - Nexthop Group Static Route, V - VXLAN Control Service,
       DH - Dhcp client installed default route

Gateway of last resort:
 K      0.0.0.0/0 [40/0] via 10.0.2.2, Management1

 B I    10.0.0.1/32 [200/0] via 10.1.2.1, Ethernet1
 C      10.0.0.2/32 is directly connected, Loopback0
 C      10.0.2.0/24 is directly connected, Management1
 C      10.1.2.0/30 is directly connected, Ethernet1



localhost#show ip route bgp

VRF: default
Codes: C - connected, S - static, K - kernel,
       O - OSPF, IA - OSPF inter area, E1 - OSPF external type 1,
       E2 - OSPF external type 2, N1 - OSPF NSSA external type 1,
       N2 - OSPF NSSA external type2, B I - iBGP, B E - eBGP,
       R - RIP, I L1 - IS-IS level 1, I L2 - IS-IS level 2,
       O3 - OSPFv3, A B - BGP Aggregate, A O - OSPF Summary,
       NG - Nexthop Group Static Route, V - VXLAN Control Service,
       DH - Dhcp client installed default route

 B I    10.0.0.1/32 [200/0] via 10.1.2.1, Ethernet1

...