| Exercise 1 | Configure an Internet Path .. |
|---|---|
| Step 1 | Gather PCI Addresses for Datacenter Router 1 |
| PCLI bosdc1 | su admin
>> wan1 PCI address |
| Step 2 | Configure WAN Interface on Datacenter Router 1 |
Configuration > Authority > Routers: seabo1 > Node: node1 > ADD Device Interface: wan1 ADD Network Interface: wan1 ADD next to Interface Addresses: 3.3.3.128 SET: Prefix: 24 SET: Gateway: 3.3.3.1 | |
| Step 3 | Gather PCI Addresses for Branch 1 Router |
| PCLI seabo1 | su admin
>> wan1 PCI address |
| Step 4 | Configure WAN Interface on Branch Router 1 |
Configuration > Authority > Routers: seabo1 > Node: node1 > ADD Device Interface: wan1 ADD Network Interface: wan1 ADD next to Interface Addresses: 1.1.1.128 SET: Prefix: 24 SET: Gateway: 1.1.1.1 | |
| Step 5 | Apply Internet Neighbourhood and Vector |
| bosdc1 | Configuration > Authority > Routers: bosdc1 > Node: node1 > Device Interface: wan1 > Network Interface: wan1 > neighborhoods CHECK: Topology: hub Vector: broadband |
| seabo1 | Configuration > Authority > Routers: seabo1 > Node: node1 > Device Interface: wan1 > Network Interface: wan1 CHECK: Topology: spoke Vector: broadband |
| VALIDATE and COMMIT | |
| Step 6 | Verify MPLS Neighbourhood and Apply Vector |
Configuration > Authority > Routers: bosdc1 > Node: node1 > Device Interface: mpls1 > Network Interface: mpls1 > neighborhoods | |
Configuration > Authority > Routers: seabo1 > Node: node1 > Device Interface: mpls1 > Network Interface: mpls1 > neighborhoods | |
| Step 7 | Verify Two Links |
| Web GUI | Select: Topology Verify there are 2 links between the Seattle Router and Boston Router |
Click on the Seattle Router and CLICK: "Show Stats" and "LOAD PEER PATHS" | |
| PCLI | show peers router bosdc1 |
| show peers router seabo1 |
| Exercise 2 | Configure Path Preference |
|---|---|
| Step 1 | Verify Old WAN Link on Branch 1 Router |
| Step 2 | Configure Service Policy |
| Step 3 | Verify Path Preference |
| Exercise 3 | Configure a 2nd Service with a Different Path Preference |
|---|---|
| Step 1 | Configure Service |
| Step 2 | Configure Service Route |
| Step 3 | Gather PCI Addresses for Datacenter Router 1 |
| Step 4 | Configure Interface on Datacenter Router 1 |
| Step 5 | Configure Service Policy |
| Step 6 | Verify Server2 Connectivity |
| Step 7 | Verify Path Preference |