Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 3 Current »

It's similar to CCC but with label stacking ( Tunnel/LSP and VC labels )


1- In the core: 

  • MPLS enable on core interfaces
  • LDP enable on core interfaces:  to create MPLS LSP ( or RSVP for LDP over RSVP )
  • extended LDP session ( targeted-LDP for Alcatel/Nokia )  enable on l0.0 interface
  • single-area OSPF  / Single IGP domain ( BGP or RVSP not needed )

2- PE Router: extended LDP session

  • Neigbor IP@
  • outgoing interface
  • VC-ID ( same both end!!!)

3- PE Router:  VPN service

  • interface and logica interface:   Layer 2 VPN interfaces
  • CCC or TCC encapsulation

3- CE Router



CCC encapsulation:  same vlan at both end

TCC encapsulation: different vlan used by CE



Configuration of l2circuit 
#Core interface
set interfaces ae0 description "to-P router"
set interfaces ae0 mtu 9192
set interfaces ae0 aggregated-ether-options lacp active
set interfaces ae0 aggregated-ether-options lacp periodic fast
set interfaces ae0 unit 0 family inet address 10.1.2.1/30
set interfaces ae0 unit 0 family iso
set interfaces ae0 unit 0 family mpls

#IGP: ISIS
set protocols isis reference-bandwidth 100g
set protocols isis max-areas 10
set protocols isis level 1 authentication-key "l1-key-here"
set protocols isis level 1 authentication-type md5
set protocols isis level 1 wide-metrics-only
set protocols isis level 2 authentication-key "l2-key-here"
set protocols isis level 2 authentication-type md5
set protocols isis level 2 wide-metrics-only
set protocols isis interface ae0.0 point-to-point
set protocols isis interface lo0.0 passive

#MPLS 
set protocols mpls path-mtu allow-fragmentation
set protocols mpls path-mtu rsvp mtu-signaling
set protocols mpls optimize-switchover-delay 30
set protocols mpls no-propagate-ttl
set protocols mpls no-cspf
set protocols mpls optimize-timer 7200
set protocols mpls interface lo0.0
set protocols mpls interface ae0.0

#LDP 
set protocols lldp interface all

# extended LDP session 
set protocols ldp interface lo0.0


#interface to CE device
set interfaces et-0/0/4 description "to-CE1 - ae4"
set interfaces et-0/0/4 ether-options 802.3ad ae4

set interfaces ae4 description "to-CE1"
set interfaces ae4 flexible-vlan-tagging
set interfaces ae4 mtu 9192
set interfaces ae4 encapsulation flexible-ethernet-services
set interfaces ae4 aggregated-ether-options lacp active
set interfaces ae4 aggregated-ether-options lacp periodic fast

set interfaces ae4 unit 121 description "ptp to customer1"
set interfaces ae4 unit 121 encapsulation vlan-ccc
set interfaces ae4 unit 121 vlan-id 121
set interfaces ae4 unit 121 input-vlan-map pop
set interfaces ae4 unit 121 output-vlan-map push

#l2circuit config
set protocols l2circuit neighbor 10.1.1.1 interface ae4.121 virtual-circuit-id 21111
set protocols l2circuit neighbor 10.1.1.1 interface ae4.121 description "l2circuit to customer1"
set protocols l2circuit neighbor 10.1.1.1 interface ae4.121 ignore-mtu-mismatch
set protocols l2circuit neighbor 10.1.1.1 interface ae4.121 pseudowire-status-tlv








  • No labels