revocery old 1- press "SPACE BAR" when asked ( Need to be quick, Just after the "FreeBSD/MIPS U-Boot bootstrap loader, Revision 2.10" paragraph ) 2- at the prompt disable watchdog : loader> watchdog disable 4- loader> type "boot -s" ( in single mode ) 5- Enter recovery mode by typing: /sbin/sh/ recovery 6- at the CLI prompt type: configuration 7- set system root-authen plain-text-password >>> type the new password [ juniper1 ] type: commit and-quit 8- type "exit" and 9- "Reboot the system? [y/n] y " | |
| EX2300-C | |
revovery mode ## Executing script at 61000000 Setting bus to 0 SF: Detected MX25L6405D with page size 256 Bytes, erase size 64 KiB, total 8 MiB device 0 offset 0x140000, size 0x140000 SF: 1310720 bytes @ 0x140000 Read: OK 7313fffc: 5a6d1cc7 ..mZ crc32 for 73000000 ... 7313ffff ==> c71c6d5a Total of 1 word(s) were the same starting USB... USB0: USB EHCI 1.00 scanning bus 0 for devices... 3 USB Device(s) found scanning usb for storage devices... 1 Storage Device(s) found SF: Detected MX25L6405D with page size 256 Bytes, erase size 64 KiB, total 8 MiB, mapped at 00000088 ## Starting application at 0x00000074 ... Consoles: U-Boot console FreeBSD/armv6 U-Boot loader, Revision 1.2 (fbsd-builder@svl-bsdx-05.juniper.net, Fri Aug 26 11:13:00 PDT 2016) DRAM: 2048MB Number of U-Boot devices: 2 U-Boot env: loaderdev not set, will probe all devices. Found U-Boot device: disk Probing all disk devices... Checking unit=0 slice=<auto> partition=<auto>... good. | Main Menu 1. Boot [J]unos volume 2. Boot Junos volume in [S]afe mode 3. [R]eboot 4. [B]oot menu 5. [M]ore options <<<<<<<<<<<<<<<<< M Choice: Main Menu 1. Boot [J]unos volume 2. Boot Junos volume in [S]afe mode 3. [R]eboot 4. [B]oot menu 5. [M]ore options <<<<<<<<<<<<<<<<<<< M Choice: Options Menu 1. Recover [J]unos volume <<<<<<<<<<<<<<<<<<< J 2. Recovery mode - [C]LI 3. Check [F]ile system 4. Enable [V]erbose boot 5. [B]oot prompt 6. [M]ain menu |