Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 4 Next »


https://docs.ipinfusion.com/service-provider/index.html#page/OcNOS-SP/MPLS-Config/TWAMP_over_EVPN_Configuration.html


Control and Test Sessions:

  • Control Session: Establishes the parameters for the test session, such as the IP addresses, ports, packet sizes, and the duration of the test.
  • Test Session: Where the actual performance measurements occur, involving the exchange of test packets between the two endpoints.
Key Metrics
  • Latency: The time taken for a packet to travel from the sender to the receiver and back.
  • Jitter: The variation in latency over a series of packets.
  • Packet Loss: The number of packets sent that are not received by the destination.
Vince's Confluence

https://ipinfusion.atlassian.net/wiki/spaces/CE/pages/91193347/TWAMP
Client Cnnfig

use local-loopback ( Sender ) and remote loopback ( receiver )

twamp config
+
hardware-profile filter twamp-ipv4 enable

R5LAB#show running-config twamp
twamp-light control
 control-admin-state enable
twamp client
 connection R6
  server ipv4 10.10.100.6
  session R6 sender-port 2000 receiver-port 2000 sender-address ipv4 10.10.100.5 receiver-address ipv4 10.10.100.6
 exit-connection



show twamp client connection

show twamp client session

show clienty
R5LAB#show twamp client connection

connection Name Server address  Server port     VRF     Status
R6            10.10.100.6           862       default       Running
R5LAB#show twamp client session

Connection name  Session name    Sender        Receiver      State
R6               R6              10.10.100.5   10.10.100.6   Session started
R5LAB#




Server Client

twamp config
R6LAB#show running-config twamp
twamp-light reflector
 reflector-admin-state enable
twamp server
 server-admin-state enable



show twamp server status

show twamp server connection

show twamp server session

show server
R6LAB#show twamp server status
Status                    : Enabled
Listening Port            : 862
Server VRF list           :
Number of connections     : 1
Number of sessions        : 1
Number of running sessions: 1



R6LAB#show twamp server connection
Connection ID                           Client Address   Client Port
            1                              10.10.100.5         46784



R6LAB#show twamp server session
Connection ID                            Session Id                                   Sender                                 Receiver       State
            1 0A.0A.64.06:E00FC1220EE2C98E:E976003A                              10.10.100.5                              10.10.100.6     Started
R6LAB#



R6LAB#show twamp server session 0A.0A.64.06:E00FC1220EE2C98E:E976003A
State           : Started
Connection ID   : 1
Session ID      : 0A.0A.64.06:E00FC1220EE2C98E:E976003A
Sender address  : 10.10.100.5
Sender port     : 2000
Receiver address: 10.10.100.6
Receiver port   : 2000
Receiver VRF    : default
Start time      : -
Timeout         : 0 sec




  • No labels